EasyManuals Logo

Microhard Systems IP920 User Manual

Microhard Systems IP920
73 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #31 background imageLoading...
Page #31 background image
IP920 Operating Manual: Chapter 4 Configuration 21
WINS Address: Windows Internet Naming Service server address to be
provided by this server.
New Binding MAC: a valid MAC address which gets the same IP address
when requesting from this DHCP server.
New Binding IP: a valid IP address will be assigned to the specific MAC
address.
Add: This action will add a new binding into the list temporarily.
Delete: a selected MAC binding can be deleted from the list.
All the parameters take effective only when the page is submitted.
4.3.4 Bridge Config ...
Spanning Tree Protocol (STP) can be enabled or disabled here to prevent
undesirable loops in the network
Figure 10 NTP Server Config
If multiple IP920 will be directly connected to a network, STP should be
enabled. STP should be disabled if only the master IP920 is connected to a
network and the other units are connected to the network indirectly.
Disabling STP can reduce network traffic to some extent.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Microhard Systems IP920 and is the answer not in the manual?

Microhard Systems IP920 Specifications

General IconGeneral
BrandMicrohard Systems
ModelIP920
CategoryNetwork Router
LanguageEnglish