Micromeritics GEMINI VII 2390 - Page 34

3 Keypad Only Installations
Function Description
E-mail Address
When connected to a network via an Ethernet connection, analysis
results can be e-mailed automatically upon completion. Enter the
email address to receive these reports. Akeyboard must be used to
complete this function. If not using DHCP and the e-mail address is
outside the local network, a gateway address must be specified.
Enter the e-mail address.
E-mail Server
Enter the numerical address of the SMTP server (the computer that is
going to deliver the results).
Your IT Department may need to configure the server to accept e-mail
from the analyzer. For proper configuration, the following information
may be required:
n IP address for the Gemini
n Sender line: Micromeritics_2390
Communications Functions (continued)
3 - 12
Gemini VII 2390 Installation Instructions and Checklist
239-42870-02 Rev (B) — May 2021