Description:
Show system name, software version, hardware version and management MAC
address. Optionally show the full configuration
[all]: Show the total switch configuration (default: System configuration only)
System Restore Default [keepIP]
Description:
Restore factory default configuration.
[keepIP]: Preserve IP configuration (default: Not preserved).
System Name [<name>]
Description:
Set or show the system name.
[<name>]: String of up to 16 characters (default: Show system name).
System Reboot
Description:
Reboot the switch.
SNMP [enable|disable]
Description:
Activate or deactivate the SNMP.
[enable|disable]: Enable/disable SNMP (default: Show SNMP mode).
Trap [<IP Address>]
Description:
Set or show SNMP traps destination.
<IP Address>: IP address to send traps to. (default: Show trap configuration)
Readcommunity [<community string>]
Description:
Set or show SNMP read community string.
[<community string>]: New community string. (default: Show current value).
To Next Page
Loading...
Need help?
General
