QoS Commands
Commands at QoS level:
QoS Configuration [<portlist>]
QoS Mode [<portlist>] [tag|port|diffserv]
QoS Default [<portlist>] [<class>]
QoS Tagprio [<portlist>] [<tagpriolist>] [<class>]
QoS DiffServ [<dscpno>] [<class>]
QoS Userprio [<portlist>] [<tagprio>]
QoS Shaper [<portlist>] [enable|disable] [<rate>]
QoS Policer [<portlist>] [enable|disable] [<rate>]
QoS Storm Control [<traffic type>] [enable|disable] [<rate>]
<class> range: low|normal|medium|high
<traffic type>: ICMP|Learn|Broadcast|Multicast|Flood Unicast
QoS Configuration [<portlist>]
Description:
Show the configured QoS mode, VLAN user priority mapping, default class, default
VLAN user priority and DSCP mapping for the port.
[<portlist>]: Port list (default: All ports).
QoS Mode [<portlist>] [tag|port|diffserv]
Description:
Set or show the QoS mode for the port.
[<portlist>] : Port list (default: All ports).
[tag|port|diffserv]: Enable tag, port or IP differentiated services
class of service for the port (default: Show mode).
QoS Default [<portlist>] [<class>]
Description:
Set or show the default class. In tag mode, the default class is used for untagged
frames. In port mode, the default class is used as the port priority. In diffserv mode,
the default class is used for non-IP frames.
[<portlist>]: Port list (default: All ports).
[<class>] : Internal class of service (default: Show default class).
QoS Tagprio [<portlist>] [<tagpriolist>] [<class>]
To Next Page
Loading...
Need help?
General
