Microsemi SyncServer S350 - Page 191

Configuring SNMP
gpsHealth OBJECT-TYPE
SYNTAXDisplayString (SIZE(1..80))
MAX-ACCESSread-only
STATUScurrent
DESCRIPTION
"This is the GPS’ receiver health status defined as
follows:
======================================================
0 = Receiver DownThe Hardware Clock can't
communicate with the receiver.
1 = Unknown Mode An undefined mode of the GPS
receiver.
2 = Acquiring SignalThe receiver is attempting to
track a GPS signal.
3 = Bad Geometry The geometry of the tracked
satellites is unsatisfactory for
a position solution.
4 = Propagate Mode A position estimation mode used
in highly dynamic environments.
5 = 2d Solution The receiver is able to perform
position fixes for latitude and
longitude but does not have
enough satellites for altitude.
6 = 3d Solution The receiver is now able to
perform position fixes for
latitude, longitude and altitude.
7 = Position Hold Position fixes are no longer
attempted, and the user entered
or surveyed position is used.
8 = Time Valid The receiver has valid timing
information from GPS satellites
(including current leap second
information).This is the final
state for all configured GPS modes.
======================================================"
::= {gps 3}
gpsSatlist OBJECT-TYPE
SYNTAXDisplayString (SIZE(1..128))
MAX-ACCESSread-only
STATUScurrent
DESCRIPTION
997-01520-02 Rev. F1.......................................................................... Page 191