Microsemi SyncServer S350 - Page 192

Tasks
"Displays the GPS satellite tracking information in the
format of:
N,X1,Y1,Z1,...,XN,YN,ZN
defined as follows:
======================================================
N Number of satellites. If one or more satellites
are available, Xi,Yi,Zi follows N.
XiSatellite vehicle number.
YiSatellite signal strength in dBW where less
than -200 dBW means no signal.
Zi Zi can be either T or C. T(racking) means the
SyncServer receives the information from the
satellite but the information is not used in its
timing solution. C(urrent) means the SyncServer
currently uses satellite information in its
timing solution.
Examples
For no satellites:
0
For one satellite with vehicle number 16:
1,16,C,-158
For six satellites:
6,12,C,-156,14,C,-155,8,T,-162,24,C,-158,18,C,161,6,C,-160
======================================================"
::= {gps 4}
gpsMode OBJECT-TYPE
SYNTAXDisplayString (SIZE(1..80))
MAX-ACCESSread-only
STATUScurrent
DESCRIPTION
"The mode of the GPS receiver defined as follows:
======================================================
Receiver Mode: Survey.
The receiver is surveying and averaging its position.
When it has finished surveying, the receiver switches
to Position Hold mode. Survey mode and Position Hold
mode are appropriate for static applications, such as a
typical server room environment. This is the default mode
when the SyncServer starts.
Page 192..........................................................................997-01520-02 Rev. F1