A ll electrical w ork should be
undertaken by a suitably q ualified
and competent person in strict
accordance w ith current national
and local safety regulations.
Installation, repairs and other w ork
by unq ualified persons could be
dangerous. The manufacturer
cannot be held liable for
unauthorised w ork.
E nsure pow er is not supplied to the
appliance until after installation or
repair w ork has been carried out.
The v o ltag e and c o nnec ted lo ad are
given on the data plate, visible below
the oven interior, w ith the door open.
E nsure that these match the household
mains supply . P lease q uote these data,
and the model and serial number w hen
contacting Miele.
C onnection of this appliance should be
made via a fused connection unit or a
suitable isolator, w hich complies w ith
national and local safety regulations,
and the on/off sw itch should be easily
accessible after the appliance has
been built in.
If the sw itch is not accessible after
installation (depending on country ) an
additional means of disconnection must
be provided for all poles.
F or ex tra safety it is advisable to install
a residual current device (R C D ). P lease
contact a q ualified electrician for
advice.
Im p o r tant
The appliance is supplied for
connection to a 230 V , 50 H z electricity
supply .
The w ires in the mains lead are
coloured in accordance w ith the
follow ing code:
G reen/y ellow = earth
B lue = neutral
B row n = live
W AR N IN G
T H IS AP P L IAN C E M U S T BE
E AR T H E D
W hen replacing the cable supplied
w ith another cable or changing the
connection, only cable ty pe
H 05 V V -F or H 05 R R -F w ith a
suitable cross-sectional area (C S A )
may be used (available from the
Miele C ustomer C ontact C entre).
Test marks . . . . . . . . . . E lectrical safety
. . . . . . . . . . . . . . . . . . . . . . C -Tick Mark
E lectrically suppressed
according to. . . . . . . . . . . A S /NZ S 1044
E lec tric al c o nnec tio n
64
To Next Page
Loading...
