Miele PFD 408 - End of the Program; Switching off; Unloading the Dishware

Operation
46
End of the program
After a program has ended normally, the
LED of the Start/Stopbutton will go out and
the following will appear on the display.

Program completed successfully
In addition to this, an audible signal will
sound for approx. 3seconds (factory de-
fault). The audible signal is repeated three
times every 30seconds. To change audible
signal settings; see “Volume”.
 Tap to acknowledge the display.
If system messages are present, they are
displayed afterward, e.g., if the salt con-
tainer level or the level of the liquid process
chemicals containers was low during the
program, or when the next service is due.
Every message needs to be acknowledged
individually by pressing OK.
Switching off
 Press the button until the display turns
off.
Unloading the dishware
Dishware tends to break and chip more eas-
ily when it is hot. Allow the dishes to cool in
the dishwasher until they are comfortable
enough to handle before unloading them.
The dishware will cool much faster if you
open the door when the program has
ended.
Unload the lower basket first, and then the
upper basket. This will prevent water drops
from the upper basket from falling onto the
dishware in the lower basket.