Troubleshooting
86
Cancel with fault code
If a program is canceled and a fault code appears, e.g., Fault F XXX (where XXX represents
a number), there could be a serious technical fault.
In the event of a program being canceled and a fault code being shown:
Turn the dishwasher off with the button.
Wait approximately 10seconds before switching the dishwasher on again with the
button.
Start the previously selected program again.
If the same fault message appears again:
Make a note of the fault message.
Turn the dishwasher off with the button.
Contact Miele Customer Service.
Please also read the notes regarding the following fault codes.
Problem Possible cause and solution
Fault F 404–405 If Check water intake appears on the display, the control
system is checking the water intake approx. every 30sec-
onds. If, after three attempts, water is not getting into the
dishwasher, one of these fault codes will appear on the
display and the program will be canceled.
Open the faucet all the way.
Turn the dishwasher off and back on again.
Select the program you want to use.
Press the Start/Stopbutton.
Fault F 407–408 Water inlet fault.
If the flow pressure is too low, one of these fault codes will
appear on the display and the program will be canceled.
The flow pressure at the water connection is too low (see
“Technical data”). Contact Miele Customer Service for
advice.
Fault F 413–414 Water inlet fault.
If the flow pressure is too high, one of these fault codes will
appear on the display and the program will be canceled.
The flow pressure at the water connection is too high
(see “Technical data”). Contact Miele Customer Service
for advice.
Fault F 433 The door was obstructed when closing and cannot be
drawn into the final closed position.
Remove the obstruction from the door area.
Fault F 438 Heavy objects in front of the machine can impede the au-
tomatic opening of the door via the Comfort Door Lock.
Do not place (heavy) objects in front of the door of the
dishwasher.
To Next Page
Loading...
