Troubleshooting
85
Faults with water inlet or drainage
Problem Possible cause and solution
One of the following fault
messages or notifications
appears on the display:
Before remedying the fault:
Turn the dishwasher off with the button.
F404 Water inlet, cold too
low: check water inlet. Open
water supply fully. Turn appli-
ance off and on. If fault per-
sists, contact service. Service
phone: Serial number:
Water inlet fault.
Open the faucet all the way.
Clean the water inlet filter (see “Cleaning and Care”).
F541 Water drainage: Turn
appliance off and on. Start
“Drain” program. Clean filter
combination and non-return
valve. If fault persists, contact
Service. Service phone: Serial
number:
Water drainage fault. There may be water in the wash cabi-
net.
Clean the filter combination (see “Cleaning and care”).
Clean the drain pump (see “Frequently asked ques-
tions”).
Clean the non-return valve (see “Frequently asked ques-
tions”).
Remove any kinks or loops in the drain hose.
To Next Page
Loading...
