Miele PFD 408 - Soft AP; Connecting Via Soft-AP

Additional settings
76
 Once the connection has been estab-
lished, Connection established will appear
on the display. Confirm the message with
OK.
If the connection fails, you have probably
not activated WPS on your router quickly
enough. Repeat the steps above.

08:15Network/WiFi
Deactivate
Set up
again
Connection
status
Reset

- Deactivate
The WiFi connection is deactivated but
the connection options are retained. The
WiFi connection can be reactivated with-
out having to repeat the connection
process.
- Connection status
Displays the IP address and the connec-
tion status of the WiFi connection.
- Set up again
Menu option for setting up a new WiFi
connection.
- Reset
Resets the WiFi connection. The connec-
tion options are lost and need to be set
up again.
Soft AP
If Connection via WPS is not possible, you
can connect the dishwasher to your local
network Via Soft AP.
A Soft-AP (Software-enabled Access Point)
is a wireless access point provided by your
dishwasher that can be used by other wire-
less machines in the vicinity.
With Soft-AP, the dishwasher is not con-
nected to the Internet. A Soft AP is only
used to connect two machines locally via
WiFi.
Connecting via Soft-AP
You can connect your dishwasher to your
WiFi network via a Soft-AP (Software En-
abled Access Point).
 When asked Which connection method do
you want to use?, select Soft AP.

OK
Follow the instructions in the
external application.
 Confirm the message by pressing OK and
follow the instructions in the external ap-
plication.
Waiting for connection will appear on the
display. This message remains active for
approx. 10minutes after selection and is
then closed.
 Once the connection has been estab-
lished, Connection established will appear
on the display.
 Confirm the message with OK.