Cleaning and care
83
Use a pointed object to push food parti-
cles that are stuck in the spray arm jets
into the spray arm.
Rinse the spray arms thoroughly under
running water.
Reinstall the spray arms and check that
they rotate freely.
Make sure that the spray arm with the yel-
low bayonet fitting is installed in the bot-
tom of the wash cabinet.
Changing the air filter (depending
on the model)
The air filter for Dry+drying must be re-
placed at regular intervals.
A message will appear on the display when
the filter needs changing.
OK
Change air filter. Then reset filter
interval (see machine functions).
Removing the plastic support
Push the snap-fit down and pull the
plastic support forward to remove it .
Replacing the filter
Remove the used filter from the plastic
support.
Insert the new filter into the plastic sup-
port with the printed side facing down
and push the plastic support into the slot
in the toe-kick until it clicks into place.
Reset the filter interval (see Machine
functions, Filter interval).
To Next Page
Loading...
