Troubleshooting
84
With the aid of the following guide, most minor problems can be corrected without con-
tacting Miele. You can save time and money in many cases, as you do not need to contact
Miele Customer Service.
The following guide should help you to find the reason for a malfunction or fault, and to
correct it. However, please note:
Danger due to incorrect repairs.
Repairs by unqualified persons can cause considerable danger to users.
Repairs should only be carried out by Miele Customer Service, an authorized Miele
dealer, or a suitably qualified specialist in accordance with local and national safety reg-
ulations.
Technical faults
Problem Possible cause and solution
The display remains dark
and the Start/Stop display
light is not flashing after
the dishwasher has been
switched on with the
button.
The electrical plug is not plugged in.
Insert the electrical plug.
The circuit breaker has tripped.
Reset the breaker
(see data plate for minimum protection rating).
The dishwasher stops dur-
ing a program.
The circuit breaker has tripped.
Reset the breaker (see data plate for minimum protection
rating).
If the circuit breaker trips again, contact Miele Customer
Service.
Power outage during oper-
ation
If a temporary power outage occurs during a program se-
quence, no measures are required.
The program which was running continues without inter-
ruption.
If the temperature in the wash cabinet drops below the
minimum value required for the program block during the
power outage, the program block is repeated.
To Next Page
Loading...
