Program settings
100
Program blocks
The wash block sequence is predefined and is the same as in the
program chart (see “Program chart”).
- Pre-rinse 1 to 3
Pre-washing removes coarse soiling and foam-building substances.
- Main wash 1 and 2
Depending on the wash load, cleaning generally occurs at tempera-
tures between 104 - 140°F (50°C and 85°C) with the addition of an
appropriate cleaning detergents.
- Interim rinse 1 to 4
In the interim rinse stages the process chemicals from the previous
wash blocks are rinsed off and neutralized where necessary by the
addition of neutralizing agents.
- Final rinse 1 to 2
To avoid deposits on the wash load, demineralized (DI) water
should preferably be used if available for the final rinse.
- Drying
Adequate drying reduces residual moisture on the load.
To Next Page
Loading...
