Maintenance measures
122
Performance check
Processing performance can be regularly confirmed by the user if re-
quired.
Test point for
measuring sen-
sors
The sensor test point for validation is located at the front right on the
top of the machine under the lid or the countertop. To reach the ac-
cess point, the lid of the machine must be removed or the machine
must be pulled out from under the countertop.
Open the door.
Unscrew the retaining screws.
Then remove the safety screws on the back of the machine from
the lid and lift the lid to remove it.
Or
Pull the machine out by approx. 6" (15cm) from under the counter-
top.
To Next Page
Loading...
