Program settings
104
The action desired at different spray arm rotational speeds is set in
each wash block.
...
Select wash block, e.g.: Main wash 1
Rinse arm monitoring
Rinse arm monitoring
On -> Warning
On -> Stop
- On -> Stop
A program in operation is interrupted if the rotational speed devi-
ates. The interruption is shown on the display and noted in the cy-
cle report.
- On -> Warning
The program continues to run normally if the rotational speed devi-
ates. Only a message appears on the display and the deviation is
noted in the cycle report.
- Off
No message appears and the program continues to run normally.
Select an option using the and arrow buttons.
Press OK to save the setting.
To Next Page
Loading...
