Frequently asked questions
133
Problem Possible cause and solution
Fault578 The peak-load cut-out has lasted longer than 3hours.
Have your electrical system and your energy manage-
ment system tested by a suitably qualified person.
Process-related faults and messages
Problem Possible cause and solution
Drying during program deacti-
vated
Drying cannot be selected at the start of a program be-
cause drying is not available for the selected program.
Start the program without drying.
Or
Have the drying parameters for this program adjusted by
Miele Service.
Wrong code entered The PIN code entered is not the same as the code saved.
Enter the PIN code again.
Report the loss of the PIN code to Miele Service.
Test program: Test object
can now be removed
This is not a fault.
A test program is running to check performance. At certain
points in the program, the sequence is interrupted so that
samples can be taken.
Take a sample.
or
Wait. The program will continue automatically in approx.
30 seconds.
or
Continue the program without delay by pressing the
Start/Stop button.
Program cancelled This is not a fault.
A program which was running was canceled by the user.
The wash cabinet interior can be very hot.
When the door is opened, hot steam and process chemi-
cals can escape. Protective measures for personal safety
must be observed.
Program continued This is not a fault.
The process of canceling a program was not completed.
The program which was running continued without inter-
ruption.
Peak load cut-out
This is not a fault!
Individual components of the machine are paused while
there is a peak load signal from your energy management
system.
To Next Page
Loading...
