5. Adding detergent
39
Detergent dispenser drawer
Add detergent in accordance with the
value in the dosage display.
The percentage shown relates to the
amount of detergent recommended by
the manufacturer on the packaging.
40% = Add slightly less than half
the amount recommended
50% = Add half the amount
recommended
60% = Add slightly more than half
the amount recommended
75% = Add three quarters of the
amount recommended
100% = Add the full amount of the
detergent recommended
Take the hardness level of your water
into account.
Too little detergent results in:
– laundry not getting properly clean
and with time it may become grey
and hard to the touch.
– greasy particles clinging to the
laundry.
– limescale deposits on the heater
elements.
Too much detergent results in:
– excessive foam which causes a low
level of agitation and poor wash,
rinse and spin results.
– high water consumption (an
additional rinse cycle will
automatically switch in).
– a greater burden to the environment.
Pull out the detergent drawer and add
detergent to the compartments.
Detergent for the pre-wash (divide the
total recommended amount as follows:
add
1
/
3
to compartment and
2
/
3
to
compartment )
Detergent for the main wash, including
Soak if selected
/
Fabric softener, liquid starch or
capsules
See "Detergent" for further information.
To Next Page
Loading...
