Spinning
43
Omitting the final spin (Rinse
hold)
Select the Rinse hold option. The
laundry is not spun after the final
rinse and remains in the final rinse
water. This helps prevent creasing if
the laundry is not going to be
removed from the drum immediately
after the end of the programme.
To start the final spin:
Touch the Change sensor.
Select Spin speed and set the spin
speed you want.
Start the final spin with the Start/Stop
sensor.
To end the programme:
Touch the Change sensor.
Select Spin speed and set the spin
speed to 0 rpm (no spin).
Touch the Start/Stop sensor.
The water will drain away.
Omitting rinse and interim spin
and the final spin
Touch the Spin speed sensor.
Select the 0 rpm setting.
After the last rinse, the water will be
pumped away and the Anti-crease
phase will switch in.
In some programmes an additional rinse
is introduced with this setting.
To Next Page
Loading...
