Miller Bobcat 225D PLUS - Maintenance and Troubleshooting; Maintenance

OM-404 Page 24
7-2. Maintenance Label
DEUTZ/RUGGERINI MD151 DIESEL ENGINE
Check
Recommended Oil API Service Classification. . . . . . . . . . . . . .
CD, SF/CD, CC/CD or better
Oil Change 200 hours or less. . . . . . Oil Filter Change normal conditions - 200 hours. .
or less
Oil Filter MILLER 066 702,. . . . . . . . .
Deutz 77-175-24
Oil Capacity 1.9 qt (1.8 L) or. . . . . .
2 qt (1.9 L) with filter change
+
S-173 094-B
Spark Arrestor Inspection And Service 250 operating hours –. . . . . . . . . .
see Owner’s Manual
Fuel Grade 1-D or 2-D Cetane No. 40 min. (.5% max. Sulfur content). . . . . . . . . . . Primary Fuel Filter MILLER 066 113. . . . . Secondary Fuel Filter MILLER 066 893, Deutz 77-175-19. . . Fill filter with clean fuel before installing – read instructions on filter.
Engine RPM – No Load Weld/Power 3750. . . . Idle 2000. . . . . . . . . . .
Air Filter Service 50 hours or less – see Owner’s Manual. . . . . . .
Injectors MILLER 066 852, Deutz 77-644-56. . . . . . . . . . . . . . Have only trained technician maintain injection pump and injectors. AIR, WATER, or GASOLINE will harm the injection system.
Optional
Diesel
See Engine Manual for complete engine care. Give Engine Specification and Serial Number when ordering parts.
daily.
°C
+30 +20 +10
0
-10 -20
°F
Single
20W
30
10W
+32
-18
+59
+104
+86
50
12 Volt Battery BCI Group 58. . Cranking Performance at 0°F (-18
°C) 430 Amps. . . . . . . .
Valve Clearance –Cold Intake 0.006 in (0.15 mm). . . Exhaust 0.006 in (0.15 mm).
Do NOT
use ether.
+40
40
Engine Cooling Avoid recirculation of air from hot air exit to blower intake.
Push And
To Drain Oil:
Pull
1/2 in. ID Hose
Turn CCW
SAE 15W-40
+5
SAE 10W-30
Viscosity Oils
Multi-
Viscosity Oils
+68