Miller Millermatic 252 - Section 10 - Parts List

OM-230693 Page 48
F
Complete Parts List is available at www.MillerWelds.com
SECTION 10 – PARTS LIST
A. Drive Roll And Wire Guide Kits
Base selection of drive rolls upon the following recommended usages:
6 V-Grooved rolls for hard wire.
7 U-Grooved rolls for soft and soft shelled cored wires.
8 U-Cogged rolls for extremely soft shelled wires (usually hard surfacing types).
9 V-Knurled rolls for hard shelled cored wires.
10 Drive roll types may be mixed to suit particular requirements (example: V-Knurled roll in combination with U-Grooved).
Wire Diameter
Kit No.
Drive Roll
Inlet Wire Guide
Fraction Decimal Metric Part No. Type
.023/.025 in. .023/.025 in. 0.6 mm 087131 079130 V-Grooved 056192
.030/.035 in. .030/.035 in. 0.8/0.9 mm 204579 203526 V-Grooved 056192
.030 in. .030 in. 0.8 mm 079594 053695 V-Grooved 056192
.035 in. .035 in. 0.9 mm 079595 053700 V-Grooved 056192
.045 in. .045 in. 1.2 mm 079596 053697 V-Grooved 056192
Ref. S-0026-B/7-91
B. MDX Welding Gun Consumables
See OM-282976 (shipped with this product) for information on replacement consumables for the MDX welding gun.