Millipore RIOS 3 - SmartPak Flush and Rinse Procedures

INSTALLATION
FLUSH MODE
ATTENTION
The Tank Outlet Valve should be left open
during FLUSH mode.
H
I
J
 The system will now go into FLUSH mode for 15
minutes (H). This is done to empty the SmartPak of
air and hydrate the material inside.
 When FLUSH mode is finished, the system will go
into FILLING TANK mode automatically (I).
R
INSING THE SMARTPAK
 Let FILLING TANK mode run for 15 minutes with
the Tank Outlet Valve open. This will completely
rinse the purification media inside the SmartPak.
 Close the Tank Outlet Valve (J). The tank will start
to fill up with water. It could take approximately
1. 5 to 2 hours to fill the tank. When it is full, the
Display will indicate a full tank by illuminating the
symbols representing the Tank Level
(see Section
5-1 Understanding the Display)
.
The Vent Filter needs to be installed. See
Section 4-5
Installation of the Vent Filter
.
- 16 -