Millipore RIOS 3 - Flush Mode; Rinsing the Smartpak

MAINTENANCE
FLUSH MODE
ATTENTION
The Tank Outlet Valve should be left open
during FLUSH mode.
H
I
J
 The system will now go into FLUSH mode for
15 minutes (H). This is done to empty the
SmartPak of air and hydrate the material
inside.
 When FLUSH mode is finished, the system will
go into FILLING TANK mode automatically (I).
R
INSING THE SMARTPAK
 Let FILLING TANK mode run for 15 minutes
with the Tank Outlet Valve open. This will
completely rinse the purification media inside
the SmartPak.
 Close the Tank Outlet Valve (J). The tank will
start to fill up with water. It could take
approximately 1. 5 to 2 hours to fill the tank.
When it is full, the Display will show the Tank
Level filled to the 100% level.
- 25 -