USING THE RIOS
5-3 OPERATING MODES
STANDBY
STANDBY mode is displayed when the front cover
is removed. The system will depressurize during
which STANDBY will be blinking on the Display for
10 seconds. All system operations are disabled.
STANDBY mode is selected before attempting
maintenance on the system.
F
LUSH
FLU (FLUSH) mode is displayed for 15 minutes after
a new SmartPak has been installed and the front
cover has been closed. FLUSH mode allows tap
water to enter and rinse the new SmartPak. The
Tank Outlet Valve must be opened during the FLUSH
cycle to keep the tank from filling until the SmartPak
is rinsed.
FLUSH mode is stopped if the front cover is removed
to go into STANDBY mode. When the front cover is
closed, FLUSH mode resumes from the last
remaining time on the Display.
If the system is powered OFF during FLUSH mode
and powered back ON, then a new FLUSH cycle
will start.
The system will have a 2 minute FAST FLUSH cycle
every 24 hours of TANK FULL mode.
- 19 -
To Next Page
Loading...
