MIMAKI CG-60AR - Copying Settings from Other User Settings [CONFIG COPY]; Restoring Default Settings [SETUP RESET]; Changing Users [USER CHANGE]

Chapter 4 Helpful Tips
129
Copying Settings from Other User Settings [CONFIG COPY]
1
Press the [FUNCTION] key in local mode.
2
Use to select [SET UP], then press the [ENTER/HOLD] key.
3
Use to select [CONFIG COPY], then press the [ENTER/HOLD] key.
4
Use to select the user setting number to be copied, then press the [ENTER/HOLD] key.
• The selected user settings are copied to the current user.
• The settings are retained even when the power is turned off.
5
Press the [END] key several times to exit.
Restoring Default Settings [SETUP RESET]
1
Press the [FUNCTION] key in local mode.
2
Use to select [SET UP], then press the [ENTER/HOLD] key.
3
Use to select [SETUP RESET], then press the [ENTER/HOLD] key.
• The current user settings and parameters are reset.
The other user settings will not be reset.
• The network settings, event email settings, and remote control settings will not be reset.
• The reset settings are retained even when the power is turned off.
4
Press the [END] key several times to exit.
Changing Users [USER CHANGE]
This machine allows settings (cutting conditions, distance correction, and main unit settings) to be saved
individually for up to eight users (users 1 to 8). Selecting a user number corresponding to the user allows the
configuration to be changed without the need to reset parameters.
• The user cannot be changed while cutting is suspended. Clear the data before changing the
user.
• Changing the user invalidates sheet detection. Repeat sheet detection.
1
Press the [FUNCTION] key in local mode.
2
Use to select [USER CHANGE], then press the [ENTER/HOLD] key.
3
Use to select the user number to be displayed, then press the [ENTER/HOLD] key.
4
Press the [END] key several times to exit.
4