Chapter 3 Cutting Data with Register Marks
85
3.3 Setting Register Mark Detection
Conditions
1
Press the [FUNCTION] key in local mode.
2
Press the keys to select [SET UP], then press the [ENTER/HOLD] key.
• [MARK DETECT] appears on the screen.
3
Press the [ENTER/HOLD] key.
• [MARKDETECT: OFF] appears on the screen.
4
Press the keys to select the number of register marks to be detected, then press the
[ENTER/HOLD] key.
• Settings: OFF, 1pt, 1ptA, 2ptB, 3pt, 4pt
• Register mark detection is not performed when "OFF" is selected. Press the [END] key several
times to exit.
5
Pressing the [ENTER/HOLD] key toggles through the following items on the display. Use
the keys to select the setting, then press the [ENTER/HOLD] key.
• Scale compensation/Register mark size/Offset A/Offset B/Form of registration mark/Number of
continuous cutting in direction A/Number of continuous cutting in direction B/High-speed limit/Skew
check/Detect mode/Sensor sensitivity/Filled in register marks/Data ID code
"Notes on Register Mark Detection Setting Items"(P. 85)
6
Press the [END] key several times to exit.
Notes on Register Mark Detection Setting Items
l
Register mark detection points setting [MARK DETECT]
Increasing the number of detection points increases the cutting accuracy.
• When cutting using , set to "1pt". The number of register mark detection points set in takes
precedence.
Setting Details
OFF Cuts without detecting register marks. Set this when cutting normal sheets.
1pt Detects register mark 1 and only sets the origin.
2ptA Detects register marks 1 and 2, and performs tilt correction and scale compensation in the
sheet feed direction.
2ptB Detects register marks 1 and 3, and performs tilt correction and scale compensation in the
width direction.
3pt Detects register marks 1 to 3, and performs tilt correction and scale compensation in the
sheet feed and width directions.
4pt Detects register marks 1 to 4, and performs tilt correction and three-point scale
compensation in addition to trapezoidal correction.
3
To Next Page
Loading...
