MIMAKI CG-60AR - Installing Cutting Software and Plotter Driver

Chapter 1 Before Using This Machine
20
l
Removing the cutter guard
1
Remove the pen-type cutter.
Pen-type cutter
2
Remove the carriage cover.
• "Remove the carriage cover."(P. 17)
3
Remove the cutter guard from the pen shaft.
Pen shaft
Cutter guard
4
Reattach the carriage cover.
• "Reattach the carriage cover."(P. 18)
Installing Cutting Software and Plotter Driver
The following two Mimaki software applications are available for cutting:
Software name Explanation
Plug-in software allowing processes from design to cutting data
creation and output to a cutting plotter to be performed within
Adobe
®
Illustrator
®
.
Simple POP Design software allowing easy creation of POP data for printing and
cutting.