Chapter 2 Cutting
50
l
Load a roll sheet.
1
Place a roll sheet on the roll-placing tables or roll bars (the legs are optional).
• Be sure to mount with the sheet facing in the correct direction.
2
Push back the clamp lever to raise the pinch rollers.
3
Pass the sheet through the platen.
• Insert the sheet between the pinch rollers and the grit rollers.
• Align the right edge of the sheet using the vertical ribs on the platen.
4
Move the pinch rollers to suit the sheet width.
• "Moving the Pinch Rollers"(P. 55)
• Move the pinch rollers to be least 5 mm inside the sheet edges. Incorrect positioning may cause
the sheet to become offset during sheet feeding.
To Next Page
Loading...
