Chapter 2 Cutting
61
2
Insert the cutter holder into the tool holder.
(1) Push the brim of the cutter holder against the tool holder.
(2) Put the brim of the cutter holder into the tool holder.
3
Secure the cutter holder.
• Turn the knob screw and fix the holder presser.
• Failure to secure firmly may result in lower quality.
Installing the (Supply) Cutter in the Cutter Holder (SPA-0090)
1
Remove the cap from the cutter holder.
• Turn in the direction indicated by the arrow in the picture.
2
Insert the cutter into the cutter holder.
• Use tweezers to insert the cutter.
3
Fix the cap by turning in the direction indicated by the arrow in the picture.
2
To Next Page
Loading...
