Chapter 3 Cutting Data with Register Marks
91
5
Set using .
• Press the [ENTER/HOLD] key to proceed to the next scale compensation setting.
• If [MARK DETECT] is set to [2ptA], the screen for entering distance B does not appear.
• If [MARK DETECT] is set to [2ptB], the screen for entering distance A does not appear.
• If [MARK DETECT] is set to [1pt], the origin is displayed, and the scale compensation screen does
not appear. (Step 7)
6
Press the [ENTER/HOLD] key after setting.
• Register mark detection starts.
• [ERROR C36 MARKdetect] appears on the display if no register marks can be detected.
If this occurs, reload the sheet.
• For more information on the number of register marks detected, refer to "Register mark
detection points setting" ( "Register mark detection points setting [MARK
DETECT]"(P. 85)).
7
Display the origin.
• The available cutting area is displayed following register mark detection, before switching to local
mode.
l
Detection procedure using rear specification
The sheet must be loaded from the rear.
1
Perform steps 1 to 3 of "Detection procedure using front specification" ( "Detection
procedure using front specification"(P. 90)).
3
To Next Page
Loading...
