Chapter 3 Cutting Data with Register Marks
93
Detection procedure using front specification
1
Load the sheet, then pull the clamp lever toward you.
• The sheet is held by the pinch rollers.
2
Press to start sheet detection. (Load from rear)
• If [ROLL. SELECT] is set to [ON], select the number of pinch rollers to be used. "Setting the
Number of Pinch Rollers to Use"(P. 56)
• Once the sheet has been detected, the display indicates that the machine is waiting for register
mark detection.
• When loading from the front, the positions of TP1 to TP4 will be reversed, as shown in the figure.
3
Use to move the LED pointer close to the center of the register mark detection
position, as shown in the following figure.
Allow 1 mm or
more
Register mark
detection position
Register mark
shape: Type 1
Register mark
shape: Type 2
4
Press the [ENTER/HOLD] key.
• The scale compensation setting screen appears.
3
To Next Page
Loading...
