Name: MIMAKI CJV30 Series
Brand: MIMAKI
Rating: 5 (1 reviews)

To Next Page

To Previous Page

7.1.1 P.2

7.1.1 Concerning Errors and Malfunctions

 Checking procedure

This section describes troubleshooting procedures for the problems for which error messages are displayed.

1. Identifying the error category

The causes of errors can be classified into the following categories:

 Handling error on the host computer side

 Trouble on the host computer side

 Trouble with the interface cable

 Printer handling error

 Printer mechanical trouble

 Printer hardware trouble

 Printer firmware trouble

2. Initial action

Refer to the error message, and judge whether the trouble lies on the host computer side or on the printer side.

 Has any of the interface conditions (printer model setting, command, communication conditions, etc.) been

changed?

 Does the trouble occur under specific conditions?

 Does the same trouble occur repeatedly?

3. Failure on the printer side

Take the following steps to repair the printer.

 Replace the defective part (sensor, etc.) or make the necessary adjustment.

 Replace the main PCB assy.

4. Repair at the factory

If the error recurs even after the corrective measures specified here are taken, return the plotter to the factory of

MIMAKI for repair.

R.1.0

Maintenance Manual > Troubleshooting > Details on Errors and Malfunctions > Concerning Errors and Malfunctions

Model CJV30/TPC Issued 2008.08.04 Revised F/W ver. 1.00 Remark

1.0

Rev.

Questions and Answers:

Need help?

Do you have a question about the MIMAKI CJV30 Series and is the answer not in the manual?

MIMAKI CJV30 Series Specifications

General