3-5
Chapter 3 Setup
3
2
2
2
4
Press the key.
• Start the pattern printing.
• Multiple test patterns are printed. (The printed
patterns are called Pattern 1, Pattern 2, Pattern
3... in the order of printing.)
5
Press to enter a correction
value of Pattern 1, and then press the
key.
• Corrected feeding rate: -40 to 40
• Check the test patterns. The position where an
outward feeding line and a return feeding line
become one straight line is the correction value.
• When the correction value in not between -40 and
40, adjust the height of the printing heads and
then perform the operations in Step 2 and later.
6
In the same way as in Step 4, enter a
correction value of Pattern 2 and later, and
then press the key.
7
Press the key several times
to end the setting.
Setting the HEATER
Pre-heater /Print heater / Post-heater are equipped on the
platen.
1
Press the (MENU) key
in LOCAL.
• SETUP MENU will be displayed.
2
Press twice, and then press the
key.
• “HEATER” will be selected.
3
Set each heater temperature by pressing
.
• Heater selecting :by the [][] keys
• Temperature setting :by the [][] keys
4
Press the key several times
to end the setting.
Setting of Logical Seek
The head’s operation varies depending on the LOGICAL
SEEK settings, as shown in the figure below.
1
Press the
(MENU)
key in
LOCAL.
• SETUP MENU will be displayed.
2
Press , and then press the
key.
• “LOGICAL SEEK” will be selected.
3
Press to select a set value, and
then press the key.
• Set value : HOST / ON / OFF
4
Press the key several times
to end the setting.
Type of HEATER
Function
Pre-heater
Used for pre-heating of the media prior to
printing to prevent rapid temperature changing.
Print-heater Improves the image quality in printing.
Post-heater Dries ink after printing.
• press [FUNC3] (off) in Step 3 to turn all heaters
OFF.
or, press [FUNC1] to raise all heaters by 10°C.
UNI-DIRECTIONAL BI-DIRECTIONAL
Movement of heads when LOGICAL seek is OFF
Movement of heads when LOGICAL seek is ON
UNI-DIRECTIONAL BI-DIRECTIONAL
Media
Red arrow :
Movement of head
Print erea
Red arrow :
Movement of head
Print erea
Media
Media Media
To Next Page
Loading...
