4-5
Chapter 4 Setup
4
2
2
Mark blurred
If the mark is blurred, a wrong mark origin can be
detected, thus resulting in deviated cutting.
Precautions on registration mark
detection
• When you retry sheet detection, sheet inclination compensa-
tion, scale compensation between registration marks, and the
position of the origin are cleared.
• Once the plotter detects marks, it will set the origin at the loca-
tion of TP1.
You can change the position of the origin to a different location
using jog keys ; the origin at the new location supersedes the
origin at TP1.
• Locate registration marks so that the line connecting the cor-
ners of four marks forms a rectangle.
Registration marks arranged unevenly can result in deviated
cutting.
• Automatically disabled if the rotation function is specified.
Notes for the combined operation of
print & cut
When performing combined operation of print & cut with
Raster Link Pro 4 SG or later, be careful to the following
items:
(1) When performing combined operation of print & cut
with the attached application software to this device
(Rasater Link Pro 4 SG or later / FineCut 7.0 or later /
), the following set contents will follow the instruction of
software side. Note that the contents set in this device
will be invalid.
• Register mark size
• Register mark shape
(2) The combined operation of print & cut without a
register mark is not performed under the following
conditions:
• Print & cut using the take-up device
Setting of Detecting the Registration
Marks
When you want to cut the data with registration marks,
you must set the following without fail.
The setting items of detecting the
registration marks
There are the following four setting items for registration
mark detection.
(1) MARK SIZE
Set the length of one side of the
registration mark.
(2) OFFSET Y / OFFSET X
Generally the origin will be set at the position shown
below.
However, depending on your application and the work to
be cut, the cutting position may be misaligned to the
same direction. In this case, the location of the origin can
be corrected.
(3) MARK TYPE
Select either one of the following types of registration
marks.
• Other than the above conditions, there is a
possibility of the cutting line being misaligned
depending on the printing data size. Therefore, it
is also recommended to perform the operation
with the data which has register marks for
combined operation of print & cut.
Setting Description
4 to 40mm
When the printed mark's horizontal and vertical
lengths differ from each other, set the same
value as the shorter length.
Setting Description
± 40.00mm
Use this to shift the origin position in the X
direction or Y direction.
• If the origin is located out of the available cutting
area, “ERR37 MARK ORG” will be displayed. In
this case, write the registration marks in the area
closer to the center of the media.
Setting Description
Type 1
Type 2
Mark: Type 1 Mark: Type
Orugin
Plus Y
direction
Plus X directionPlus X direction
Orugin
Plus Y
direction
To Next Page
Loading...
