4-6
Chapter 4 Setup
(4) DETECT MODE
(5) SENSOR LEVEL
Method of detecting registration marks
1
Set a media. ( P.2-4)
2
Press , to perform the media
detection.
• Once the media is detected, the display indicates
that the machine is waiting for registration mark
detection operation.
3
Press , to move the
Light Pointer into the area shown below.
4
Pressthe key.
• The scale compensation display appears.
5
Make setting with .
• Press the [ENTER] key to change the display to
the next scale compensation setting.
• If [DIST.REVI.] is set to [OFF], the display for
scale compensation setting will not appear.
• If [TP DETECT] its set to [2ptA], the display for
inputting the B length will not appear.
• If [TP DETECT] is set to [1pt], the scale
compensation setting display will not appear but
the origin point will be displayed.
6
Press the key after completing
the settings.
• The machine will start detecting the registration
marks according to the settings of [TP DETECT].
• In case the plotter cannot detect any registration
marks, it displays “Error C36 in the registration
mark detection” on the display. Set the sheet
again.
7
Set the origin.
• The display will show the available cutting area
and then return to local.
Setting Description
FAST
The position is determined by scanning the
registration mark segment back and forth once.
Time required for detection is short, however,
the accuracy becomes lower a little.
PREC
After scanning the registration mark segment
back and forth once, measures the position
without fail by scanning the segment included
its outside again.
Time required for detection becomes slightly
longer.
Setting Description
1 to 7
The bigger the numerical value is, the higher
the sensitivity of the registration mark sensor
becomes.
If it detects the registration mark by mistake,
lower the sensitivity. Generally, use it with the
setting value of “4”.
• If the sheet is curled, straighten it.
When using a cutting software having no mark
function, use a media which has neither stains nor
images in the area (A) located between TP1 and
TP2 and in the area (B) located between TP1 and
TP3.
1 mm or more
away
Mark detection
position
Mark
:Type 1
Mark
:Type 2
To Next Page
Loading...
