© 2014 MIMAKI ENGINEERING CO.,LTD. 4.2 P.9
4.2 Assembling the Stands and the Device
R.1.0
1
2
3
4
5
6
7
20. Check the position of roll stopper arm.
21. Insert the cable of the take-up device into the connector on the
bottom surface of electric unit.
22. Using the screw (M5x15), connect the ground line to the right
leg of the take-up device unit.
Roll Stopper Arm
Roll Stopper
Roll Holder Side (Side of the unit)
INSTALLATION GUIDE > Printer Assembly > Assembling the Stands and the Device
Model
JV300
Issue
2014.04.11
Revised F/W ver.
1.00
Remark
1.0
To Next Page
Loading...
