– 1.9 –
Print Resolution of JV4 series and Notes on specified media.
Resolution Notes / Limitations
360 x 360 • Mat media • Since the dot size of JV4 is smaller than that of JV2 for the
360 dpi mode, panting is more distinctive. The use of 360 x
540dpi mode is recommended.
• Since the 2 pass mode is subject to panting by media feed
accuracy variation or stripes or uneven plotting by curved
nozzle fly, the use of media with a dot size of 120µm or more
is recommended.
• If the dot size is small, make plotting in the 4 pass mode or
higher mode to make panting less distinctive. These modes
need less amount of feed, improving the accuracy. Panting
can also be reduced through software processing.
•Glossy and film media are not suitable for JV4 because they
may cause insufficient concentration, white stripes, and
uneven plotting since the necessary dot size cannot be
obtained.
360 x 540 • Mat media • The use for applications allowing sufficient concentration
with general mat media or for high- speed output applica-
tions is recommended.
• Since the 3 pass mode is subject to panting by media feed
accuracy variation or stripes or uneven plotting by curved
nozzle fly, the use of media with a dot size of 90µm or more
is recommended.
• If the dot size is small, make plotting in the 6 pass mode or
higher mode to make panting less distinctive. These modes
need less amount of feed, improving the accuracy. Panting
can also be reduced through software processing.
360 x 720 • Tarpaulin media, etc • Use media with high ink absorption factor.
720 x 720 • Glossy media • Since the 4 pass mode is subject to panting by media feed
accuracy variation or stripes or uneven plotting by curved
nozzle fly, the use of media with a dot size of 70µm or more
is recommended.
• If the dot size is small, make plotting in the 8 pass mode or
higher mode to make panting less distinctive. These modes
need less amount of feed, improving the accuracy. Panting
can also be reduced through software processing.
•With high image quality applications, the use with the bottom
head psition is reccomended for stable dot shot.
Variable Variable data involves smaller dots, requring more strict
margin for the dot size and media feed accuracy.
• Plotting with 720 dpi in the 8 pass more or higher is recom-
mended.
• If stripes or uneven plotting occures, check the rank of the
dischareged dot (Large, Middle, of Small) and then determine
whether the resolution and profile are suitable for the media.
Recommended
Media
• Glossy media
allowing the same dot
condition as MIMAKI-
brand Glossy White
PET.
•Mat media
Downloaded From ManualsPrinter.com Manuals
To Next Page
Loading...
Need help?
General
