– iii –
3-3-3. Cutting failure .....................................................................................3.11
3-3-4. Faulty cutter.........................................................................................3.11
3-3-5. Fan motor ............................................................................................3.11
3-3-6. Abnormal nozzle discharge .................................................................3.12
3-3-7. Board medium feeding failure.............................................................3.12
3-3-8. Abnormal ink discharge ......................................................................3.13
3-3-9. Ink-filling cannot be performed ..........................................................3.13
3-3-10. Abnormal wiper operation ................................................................3.13
3-4. Plotting failure ...........................................................................................3.14
3-4-1. Print is not sharp..................................................................................3.14
3-4-2. Abnormal print ....................................................................................3.15
3-4-3. Color of print is pale............................................................................3.16
3-4-4. Plotted drawing is out of position .......................................................3.16
3-4-5. Plotted dots or lines are dirty...............................................................3.17
3-4-6. Stripes are always drawn at the time of scanning ...............................3.18
3-4-7. Black and White Stripes on Reverse Sides .........................................3.19
3-4-8. Dark and Light Images Occur at Each Scan .......................................3.19
3-4-9. Stripes occur ........................................................................................3.20
CHAPTER 4 MAINTENANCE MODE....................................................... 4.1
4-1. Maintenance items .......................................................................................4.2
4-2. Entering into the maintenance mode .........................................................4.3
4-2-1. Entering into the maintenance mode when actuating the plotter ..........4.3
4-2-2. Entering into the maintenance mode by system parameters .................4.4
4-3. Menu of #ADJUST ......................................................................................4.5
4-3-1. PRINTadjust2........................................................................................4.5
4-3-2. HEAD ADJUST .................................................................................4.11
4-3-3. HEAD WASH .....................................................................................4.13
4-3-4. SELECT CLEANING........................................................................4.15
4-3-5. REPLACE COUNTER ......................................................................4.17
4-3-6. DEFAULT SET...................................................................................4.19
4-3-7. CAPPING............................................................................................4.20
4-3-8. INK SETUP.........................................................................................4.21
4-3-9. HEAD ID............................................................................................4.22
4-3-10. ADJUST EDGE ...............................................................................4.23
4-3-11. 500mmSQUARE...............................................................................4.25
4-3-12. SET QUALITY .................................................................................4.27
4-3-13. MEDIA COMP2 ...............................................................................4.28
4-4. #TEST items ..............................................................................................4.30
4-4-1. CHECK PATTERN ............................................................................4.30
Downloaded From ManualsPrinter.com Manuals
To Next Page
Loading...
Need help?
General
