MIMAKI JV5 Series Operating Manual

4-24
8
Press to select [FRAME CUT]
and press the key.
• When you want to cut a frame, select "ON".
9
Press to select [MARK CUT]
and press the key.
• When you want to attach marks for pasting, select "ON".
10
Press the key several times to return to LOCAL.
Canceling the Setting of Dividing and Cutting
• The set values are recorded even when the power has been turned OFF.
• Because a mark for pasting is 1 cm long, the width of an effective cut area needs to be 1 cm or more.
• During the operation of dividing and cutting, data sent from the host computer is ignored.
• Dividing and Cutting cannot be performed in any of the following cases:
When the data size is larger than the reception buffer capacity
When an origin change command is contained in the cut data
When two-point axis correction has been set
When register mark detection is performed
When the width of an effective cut area is 1 cm or less
When the test data stored in this machine has been cut
Perform the operations in Steps 1 to
6 in "Setting the Dividing and
Cutting Function".
Press
to select "OFF".
Press .
Press key
several times.
[CUT1]DIVISION CUT
FRAME CUT : OFF
[CUT1]DIVISION CUT
MARK CU T : ON

MIMAKI JV5 Series Specifications

General

Brand	MIMAKI
Model	JV5 Series
Category	Printer
Language	English