6-24
Setting the Refreshing Interval in the Sleep Mode
The interval between each operation of ejecting a small amount of ink from the nozzles to prevent nozzle
clogging is set.
1
Press the key in LOCAL to select the
printing mode.
2
Select [SLEEP SETUP] of the maintenance menu.
(1)Press the key.
(2)Press to select [MAINTENANCE] and press the key.
(3)Press to select [SLEEP SETUP].
3
Press the key.
4
Press the key.
5
Press to set the refreshing interval.
• Set value: OFF or 1 to 168 hours
6
Press the key.
7
Press the key several times to end the setting.
<LOCAL. 1> [ #01 ]
WIDTH:****mm
SLEEP SETUP
REFRESH < e n t >
SLEEP SETUP
REFRESH i n t e r v a l =
1 h
SLEEP SETUP
REFRESH i n t e r v a l = 1
0 h
SLEEP SETUP
REFRESH < e n t >
To Next Page
Loading...
Need help?
General