6-30
Setting the Refreshing Interval in the Standby Mode
The interval between each refreshing operation is set.
1
Press the key in LOCAL to select the
printing mode.
2
Select [ROUTINE SETUP] of the maintenance menu.
(1)Press the key.
(2)Press to select [MAINTENANCE] and press the key.
(3)Press to select [ROUTINE SETUP].
(4)Press the key.
3
Press to select [REFRESH].
4
Press the key.
5
Press to set the interval between each
refreshing operation.
• Set value: OFF or 1 to 168 hours
6
Press the key.
7
Press the key several times to end the setting.
<LOCAL. 1> [ #01 ]
WIDTH:****mm
ROUT I NE SETUP
REFRESH < e n t >
ROUT I NE SETUP
REFRESH i n t e r v a l =
1 h
ROUT I NE SETUP
REFRESH i n t e r v a l = 1
0 h
ROUT I NE SETUP
REFRESH < e n t >
To Next Page
Loading...
Need help?
General