MIMAKI JV5 Series Operating Manual

4-40
Cutting a Medium into Multiple Pieces with a Certain Length
You can cut a medium into multiple pieces with a specified length. (Automatic media-cutting function)
1
Press the key in LOCAL to select the
cutting mode.
2
Press the key.
3
Press to select [MAINTENANCE] and
press the key.
4
Press to select [MEDIA CUT].
5
Press the key.
6
Press to select a cutting interval.
• Set value: 10 to 10,000 mm
7
Press the key.
8
Press to select a length for the leading end
adjustment cutting.
• Set value: 10 to 500 mm
9
Press the key.
10
Press to select the number of times a
medium is cut (number of pieces produced by cutting a
medium).
• Set value: 1 to 9,999
Settings Set Value Overview
Cutting interval 10 to 10,000 mm Distance between the leading and terminal ends of a cut medium is set.
Leading end
adjustment cutting
10 to 500 mm The length of a medium's leading end to be cut is set before automatic media
cutting starts.
Even when the leading end of a medium has been cut obliquely or the cut
surface is not smooth, leading end adjustment cutting enables you to cut a
medium into a specified number of pieces with the same length.
Number of times a
medium is cut
1 to 9,999 The number of times a medium is cut (number of pieces produced by cutting
a medium) is set.
<LOCAL . C > [ #01 ]
FUNCT I ON C
SETUP <ENT>
MA I N T ENANCE
MARK S ENSOR < e n t >
MA I N T ENANCE
MED I A CU T < e n t >
MED I A CU T
INTERVAL = 10mm
MED I A CU T
INTERVAL = 500mm
MED I A CU T
FRONT CUT OFF= 10mm
MED I A CU T
FRONT CUT OFF= 50mm
MED I A CU T
COUNT = 1
MED I A CU T
COUNT = 1 0

MIMAKI JV5 Series Specifications

General

Brand	MIMAKI
Model	JV5 Series
Category	Printer
Language	English