7-9
Warning/Error Messages
7
Troubleshooting
Message Cause Solution
MEDIA EXCHANGE
The machine is waiting for the medium to be
replaced during continuous copying in the leaf
media mode.
Replace the leaf sheet (cut sheet) with a new
one, and resume continuous copying.
MEDIA END REM/END
End of the medium is detected while detecting a
register mark or cutting roll medium.
Cutting cannot be continued, since roll medium
has ended.
Press the key and replace it with new
medium.
The medium is lifted. Fix the lifting of the sheet and press the
key to resume cutting.
The back of the machine is exposed to intense
light.
Turn the machine around so as not to exposed it
to the light, and press the key to
resume cutting.
END
REMOTE
REMOTE
To Next Page
Loading...
Need help?
General