To Next Page

To Previous Page

Operation Flow ............................................................ 2-7

Turning the Power ON/OFF ........................................ 2-8

Turning the Power ON ..................................................2-8

Turning the Power OFF ................................................2-9

Installing Tools .......................................................... 2-10

When a Cutter Is Used ...............................................2-10

Exchanging tool ..........................................................2-13

How to Attach a Ballpoint pen .....................................2-14

Setting a Medium ...................................................... 2-15

Adjusting the Head Height ..........................................2-15

Adjusting the Position of the Pinch Roller According

to the State of a Medium .............................................2-17

Roll Stopper ................................................................2-22

Maximum Print Area/Cut Area ....................................2-23

Notes When Using Medium Holder ............................2-24

Setting a Roll Medium .................................................2-25

Take-up Device ...........................................................2-29

Setting a Leaf Medium ................................................2-31

When Changing the Origin .........................................2-33

Test Printing .............................................................. 2-35

Test Printing ................................................................2-35

Performing Head Cleaning .........................................2-36

Performing Media Correction and Dot Position

Correction ...................................................................2-36

Test Cutting ............................................................... 2-37

Preparing for the Heaters ......................................... 2-38

Changing the Temperature Settings for the Heaters ..2-38

Checking the Heater Temperature .............................2-39

Printing Data .............................................................. 2-40

Starting a Printing Operation ......................................2-40

Stopping a Printing Operation .....................................2-41

Deleting Received Data (Data Clear) .........................2-41

Data Cutting ............................................................... 2-42

Starting a Cutting Operation .......................................2-42

Stopping cutting in a while ..........................................2-42

Restarting a Cutting Operation ...................................2-42

Stopping a Cutting Operation (Data Clear) .................2-43

Removing the Cutter Unit Temporarily .......................2-43

Cutting a Medium ...................................................... 2-44

MIMAKI JV5 Series Operating Manual

Other manuals for MIMAKI JV5 Series