MIMAKI ML Tiger-1800B MKII - PLC Error List: Cycle Start, Media End, and Manual Mode Errors; Specific PLC Error Codes and Solutions

63
Error
No.
Error
level
Error displayed Cause Measures
F476
3
Cycle doesn't
START -
Maintenance
Enable reason
Under maintenance
ALARM] button.
2. If the Alarm is displayed again after tapping
the [CLEAR ALARM] button, turn off the
power of the internal PC and then the main
power of the machine in this order, and
then turn on again after a while.
3. If the Alarm appears again, contact your
dealer, our sales office, or call center.
F487
3
Carriage
movement
Safety PX Alarm
Limit sensor error in
carriage vertical
movement
F488
2
Belt Heater
Alarm
Belt heater error
F489
1 or
2
MEDIA END
Alarm
The media end was
detected in the
UNWINDER unit.
1. Check if there is a hole in the media coming
out of the UNWINDER unit . If there is a
hole, feed the media until it comes out of
the print area, then tap the [DETAIL] button
in [SYSTEM ALARM] of the MPC, and tap
the [CLEAR ALARM] button.
2. If the Alarm is displayed again after tapping
the [CLEAR ALARM] button, turn off the
power of the internal PC and then the main
power of the machine in this order, and
then turn on again after a while.
3. If the Alarm appears again, contact your
dealer, our sales office, or call center.
F512
2
Unwinder
Dancer Roll Up
Alarm
The tension bar of the
UNWINDER unit has
reached its upper
limit.
1. Level the tension bar in the local mode.
2. Check that the operation mode of the
UNWINDER unit is set to Auto.
3. Tap the [DETAIL] button in [SYSTEM
ALARM] of MPC, and tap the [CLEAR
ALARM] button.
4. If the Alarm is displayed again after tapping
the [CLEAR ALARM] button, turn off the
power of the internal PC and then the main
power of the machine in this order, and
then turn on again after a while.
5. If the Alarm appears again, contact your
dealer, our sales office, or call center.
F513
0 or
1 or
2
Unwinder
Dancer Roll
Down Alarm
UNWINDER unit
tension bar has
reached its limit.
F514
2
Unwinder Drive
FAULT
UNWINDER unit
inverter error
1. Tap the [DETAIL] button in [SYSTEM
ALARM] of MPC, and tap the [CLEAR
ALARM] button.
2. If the Alarm is displayed again after tapping
the [CLEAR ALARM] button, turn off the
power of the internal PC and then the main
power of the machine in this order, and
then turn on again after a while.
3. If the Alarm appears again, contact your
dealer, our sales office, or call center.
F515
3
Unwinder
Thermal
protection
Malfunction of power
supply or breaker of
UNWINDER unit
F516
0
WARNING
Unwinder in
MANUAL mode
UNWINDER unit is
set to manual mode.
1. Set the operation mode to AUTO on the
touch panel of the UNWINDER unit.
2. Tap the [DETAIL] button in [SYSTEM
ALARM] of MPC, and tap the [CLEAR
ALARM] button.
3. If the Alarm is displayed again after tapping
the [CLEAR ALARM] button, turn off the
power of the internal PC and then the main
power of the machine in this order, and
then turn on again after a while.
4. If the Alarm appears again, contact your
dealer, our sales office, or call center.