MIMAKI ML Tiger-1800B MKII - PLC Error List: DryerJet and Unwinder Errors; Specific PLC Error Codes and Solutions

64
Error
No.
Error
level
Error displayed Cause Measures
F517
3
DRYERJET in
Emergency
Alarm
Emergency stop
occurs in DRYERJET
1. Check the following items.
1.1 Check that the DRYERJET
emergency switches (2 places) are
released. At this time also check
whether the emergency switch on the
main unit is released.
1.2 Make sure that there is no clogging
near the media insertion slot of
DRYERJET.
1.3 Check that the area sensor of the
DRYERJET is not shielded.
2. Tap the [DETAIL] button in [SYSTEM
ALARM] of MPC, and tap the [CLEAR
ALARM] button.
3. If the Alarm is displayed again after tapping
the [CLEAR ALARM] button, turn off the
power of the internal PC and then the main
power of the machine in this order, and
then turn on again after a while.
4. If the Alarm appears again, contact your
dealer, our sales office, or call center.
F518
2
DRYERJET
Thermal
protection Alarm
DRYERJET’s power
supply or breaker
error
1. Tap the [DETAIL] button in [SYSTEM
ALARM] of MPC, and tap the [CLEAR
ALARM] button.
2. If the Alarm is displayed again after tapping
the [CLEAR ALARM] button, turn off the
power of the internal PC and then the main
power of the machine in this order, and
then turn on again after a while.
3. If the Alarm appears again, contact your
dealer, our sales office, or call center.
F519
2
DRYERJET
Inverter Alarm
DRYERJET’s inverter
error
F521
2
Unwinder FC
Cardan Alarm
Cardan joint error of
Big Roll UNWINDER
1. Check the connection part of the Big Roll
Cardan joint.
If the cardan joint is not connected to the
trolley, connect it.
2. Tap the [DETAIL] button in [SYSTEM
ALARM] of MPC, and tap the [CLEAR
ALARM] button.
3. If the Alarm is displayed again after tapping
the [CLEAR ALARM] button, turn off the
power of the internal PC and then the main
power of the machine in this order, and
then turn on again after a while.
4. If the Alarm appears again, contact your
dealer, our sales office, or call center.