MIMAKI ML Tiger-1800B MKII - PLC Error List: Seam, Paper, and Dancer Errors; Specific PLC Error Codes and Solutions

65
Error
No.
Error
level
Error displayed Cause Measures
F542
1 or
2
Seam detected
alarm
Detected a media
seaming at the Small
Roll UNWINDER.
1. Check if there is a seam near the Small
Roll Seam Detector sensor.
If there is a joint, feed the media until the
joint comes out of the print area.
2. Tap the [DETAIL] button in [SYSTEM
ALARM] of MPC, and tap the [CLEAR
ALARM] button.
3. If the Alarm is displayed again after tapping
the [CLEAR ALARM] button, turn off the
power of the internal PC and then the main
power of the machine in this order, and
then turn on again after a while.
4. If the Alarm appears again, contact your
dealer, our sales office, or call center.
F544
2
DRYERJET
Breaking Paper
Alarm
Media error on
DRYERJET
1. Check the following items.
1.1 Reset the media.
1.2 Level the tension bar in the local
mode.
2. Tap the [DETAIL] button in [SYSTEM
ALARM] of MPC, and tap the [CLEAR
ALARM] button.
3. If the Alarm is displayed again after tapping
the [CLEAR ALARM] button, turn off the
power of the internal PC and then the main
power of the machine in this order, and
then turn on again after a while.
4. If the Alarm appears again, contact your
dealer, our sales office, or call center.
F545
2
DRYERJET
Dancer UP
Alarm
The tension bar of the
DRYERJET has
reached its upper
limit.
1. Level the tension bar in the local mode.
2. Tap the [DETAIL] button in [SYSTEM
ALARM] of MPC, and tap the [CLEAR
ALARM] button.
3. If the Alarm is displayed again after tapping
the [CLEAR ALARM] button, turn off the
power of the internal PC and then the main
power of the machine in this order, and
then turn on again after a while.
4. If the Alarm appears again, contact your
dealer, our sales office, or call center.
F546
1 or
2
DRYERJET
Dancer DOWN
Alarm
The tension bar of the
DRYERJET has
reached its lower
limit.
F547
2
DRYERJET
Paper
Temperature
Alarm
Media temperature
error on DRYERJET
1 Check if the heater set temperature is 80
degree C or less.
2 Tap the [DETAIL] button in [SYSTEM
ALARM] of MPC, and tap the [CLEAR
ALARM] button.
3 If the Alarm is displayed again after tapping
the [CLEAR ALARM] button, turn off the
power of the internal PC and then the main
power of the machine in this order, and
then turn on again after a while.
4 If the Alarm appears again, contact your
dealer, our sales office, or call center.
F548
2
DRYERJET
Heating generic
Alarm
Heater error on
DRYERJET
F549
2
By Pass
DRYERJET
Alarm
Bypass of
DRYERJET is
enabled by WinGP.
1 Contact your dealer, our sales office, or call
center.