MIMAKI ML Tiger-1800B MKII - Other Error List: MDC Parameter, Config, and System Errors; Specific Other Error Codes and Solutions

77
Error
No.
Error
level
Error displayed Cause Measures
C3 04 2
C304:00(ZZZZZZZZ)TIFF read
ERROR
TIFF file reading
failure
Data created with RIP
software may be corrupted.
Check the output target
model and printing
conditions, and
create the
data again.
C3 05 2
C305:00(ZZZZZZZZ)Mask
ERROR
Mask creation failure
C3 06 2
C306:00(ZZZZZZZZ)PSTUS file
read ERROR
Invalid print condition
value
MDC Prm_Error
C4 01 2
C401:00(ZZZZZZZZ)Control
Data read ERROR
Error reading control
data
Turn off the power of the
internal PC and then the
main power of the machine
in this order, and then turn
on again after a while.
If it appears ag
ain, contact
your dealer, our sales office,
or call center.
C4 02 2
C402:00(ZZZZZZZZ)Control
Data download ERROR
Control data
download error
MDC Config_Error
C8 01 2
C801:00(Z)Target does not exist
Z indicates the number of the
Firmware that could not be
detected.
1～8:PEFW
9:IOFW
Target does not exist.
The
machine settings are
not correct. Contact your
dealer, our sales office, or
call center.
C8 02 2
C802:00(Z)PCB composition
ERROR
Z indicates the configuration error
Firmware number.
1～8:PEFW
9:IOFW
Machine configuration
error
C8 03 2
C803:00(ZZZZZZZZ)Version
ERROR
Version error
The version of the units that
configures this machine is
incorrect. Contact your
dealer, our sales office, or
call center.
MDC System_Error
C9 01 2
C901:00(ZZZZZZZZ)Program
ERROR
Program ERROR
Turn off the power of the
internal PC and then the
main power of the machine
in this order, and then turn
on again after a while.
If it appears again, contact
your dealer, our sales office,
or call center.
C9 98 2
C998:00(ZZZZZZZZ)EXCEPTIO
N(1)
Unexpected error
(other than software
exception, below)
C9 99 2
C999:00(ZZZZZZZZ)EXCEPTIO
N(2)
Unexpected error
(software exception)