MIMAKI SIJ-320UV - Page 3

ii
Changing the printing origin .............................................................2-17
Preparing for the Heaters............................................................2-18
Changing the Temperature Settings for the Heaters........................2-18
Test Printing................................................................................2-18
Test Printing .....................................................................................2-19
Head Cleaning ............................................................................2-19
About head cleaning.........................................................................2-19
Perform head cleaning depending on the test printing result ...........2-19
Setting of Media Correction.........................................................2-20
Setting of Media Correction.............................................................2-20
Correct the ink drop position for bidirectional printing .................2-21
Printing Data ...............................................................................2-22
Starting a Printing Operation ............................................................2-22
Stopping a Printing Operation ..........................................................2-22
Deleting Received Data (Data Clear) ...............................................2-22
Chapter 3 Extended Functions
About Setup MENU.......................................................................3-2
Setup MENU table..............................................................................3-3
Setting of Media Correction................................................................3-4
If the Positions of Dots Shift... ............................................................3-5
Setting the Heater ..............................................................................3-5
Setting of Logical Seek.......................................................................3-6
Setting of Overprint ............................................................................3-6
Setting of Left and Right Margins ......................................................3-7
Setting of UV mode ............................................................................3-7
Setting of Refresh...............................................................................3-9
Setting of Vacuum Fan.......................................................................3-9
Setting of Print Speed ........................................................................3-9
Setting of MAPS4 .............................................................................3-10
Setting Auto Cleaning.......................................................................3-10
Setting Interval wiping ......................................................................3-11
About Machine Setup MENU ......................................................3-12
Machine Setup MENU table .............................................................3-13
Setting a AUTO Power-off................................................................3-13
Setting Feeding unit .........................................................................3-13
Setting Take-up unit .........................................................................3-13
Setting the Display of Media Remain ...............................................3-14
Setting Time .....................................................................................3-14
Setting Unit (Temperature/ Length)..................................................3-14
Setting a Key Buzzer........................................................................3-15
Setting the Display of Media Detection ............................................3-15
Setting the CONFIRM. FEED...........................................................3-15
Initializing the Settings......................................................................3-16
About Nozzle Check MENU........................................................3-17
Nozzle Check MENU table...............................................................3-17
Printing Check Flow .........................................................................3-18
Printing Operations at “Nozzle Missing” Judgment and
Error Occurrence..............................................................................3-18
Setting the Printing Check................................................................3-19
Setting the Auto Nozzle Recoverry ..................................................3-19
Setting the Judgement Condition .....................................................3-19