MIMAKI SWJ-320 S4 - Page 161

© 2013 MIMAKI ENGINEERING CO.,LTD. 6.5.1 P.1
R.1.0
1
2
3
4
5
6
7
8
MAINTENANCE MANUAL > Disassembly and Reassembly > Sensors > Y-origin Sensor
Model SWJ-320S Issued 2012.07.19 Revised F/W ver Remark
1.0
Rev.
6.5.1 Y-origin Sensor
 Work Procedures
1. Open the right maintenance cover, and move the carriage to the
left.
2. Remove the photo sensor.
3. Reverse the disassembly procedure for reassembly.
Y-origin sensor
Screw
Photo sensor
Y-origin sensor BKT
Screw
Y-origin sensor shield plate
Carriage side
Main body side
 Check that the Y-origin sensor shield plate of car-
riage does not contact with the sensor after the sen-
sor is fixed.
In case of contacting, adjust the position, referring
to the left figure.
 After assembling, display [# TEST] -> [SENSOR]
-> [Y ORIGIN] (5.1.2 SENSOR TEST), and
then check ON/OFF.